Differences

This shows you the differences between two versions of the page.

--- windows_install [2009/10/04 01:25]
ispyisail
+++ windows_install [2013/03/28 09:21] (current)
joesiea [Introduction]
@@ Line 1: / Line 1: @@
+**Bold Text**
 ====== Fon Flash - Windows ======
-Fon Flash is currently one of the easiest method for installing Gargoyle firmware on compatible routers.
+{{INLINETOC 2 4 }}
+s===== Introduction =====
+Fon Flash is currently one of the easiest method for installing Gargoyle firmware on compatible routers (Atheros AR231X/531X but not including Ubiquiti routers).
 ===== Prerequisite =====
@@ Line 36: / Line 40: @@
 gargoyle_x.x.xx-atheros-vmlinux.gz
+{{:fon_flash4.png|}}
 ===== Full Flashing Procedure =====
-    *  Install WinPcap (only necessary for windows)
+  *Install WinPcap (only necessary for windows)
+  *Connect the ethernet cable from the AP51 router (ROBIN) to your computer
-    * Connect the ethernet cable from the AP51 router (ROBIN) to your computer
+     *May require a cross over cable or hub/switch with older equipment
+  *Power off AP51 router (unplug)
-    * May require a cross over cable or hub/switch with older equipment
+  *Start FonFlash
+  *Select Firmware Type
-    * Power off AP51 router (unplug)
+      *Gargoyle/OpenWrt/ROBIN
+      *Fonera Firmware
-    * Start FonFlash
+      *DD-WRT
+  *Select the ethernet device you are using
-    * Select Firmware Type
+  *Select the Gargoyle/ROBIN .squashfs file as the root file
+  *Select the Gargoyle/ROBIN .lzma file as the kernel file
-          * Gargoyle/OpenWrt/ROBIN
+  *Hit the Start button
-          * Fonera Firmware
+  *Wait 5 seconds
-          * DD-WRT
+  *Power on the AP51 router
+  *Wait 10 minutes - 30 minutes, until FonFlash reports that the router has been flashed
-    * Select the ethernet device you are using
+  *Wait another 2-3 minutes while the router reboots
-    * Select the Gargoyle/ROBIN .squashfs file as the root file
-    * Select the Gargoyle/ROBIN .lzma file as the kernel file
-    * Hit the Start button
-    * Wait 5 seconds
-    * Power on the AP51 router
-    * Wait 45 minutes - 1hr, until FonFlash reports that the router has been flashed
-    * Wait another 2-3 minutes while the router reboots

Gargoyle Wiki

User Tools

Site Tools

Differences

Page Tools