This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
windows_install [2009/10/04 01:08] ispyisail |
windows_install [2013/03/28 09:21] (current) joesiea [Introduction] |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | **Bold Text** | ||
====== Fon Flash - Windows ====== | ====== Fon Flash - Windows ====== | ||
- | Fon Flash is currently one of the easiest method for installing Gargoyle firmware on compatible routers. | + | {{INLINETOC 2 4 }} |
+ | s===== Introduction ===== | ||
+ | |||
+ | Fon Flash is currently one of the easiest method for installing Gargoyle firmware on compatible routers | ||
===== Prerequisite ===== | ===== Prerequisite ===== | ||
Line 11: | Line 15: | ||
Download "Fon Flash" from [[http:// | Download "Fon Flash" from [[http:// | ||
+ | ===== Run Fon Flash ===== | ||
+ | |||
+ | Once downloaded double click " | ||
+ | |||
+ | Note: Vista users will need to run as administrator. | ||
+ | |||
+ | ===== Enter Details ===== | ||
+ | |||
+ | === Select Firmware Type === | ||
+ | |||
+ | For Gargoyle select " | ||
+ | |||
+ | === Select Network Interface === | ||
+ | |||
+ | Select the network interface card which is plugged into your gargoyle router | ||
+ | === Select Rootfs file === | ||
+ | |||
+ | gargoyle_x.x.xx-atheros-root.squashfs | ||
+ | === Select Kernel file === | ||
+ | |||
+ | gargoyle_x.x.xx-atheros-vmlinux.lzma | ||
+ | |||
+ | Routers like Meraki Mini require | ||
+ | |||
+ | gargoyle_x.x.xx-atheros-vmlinux.gz | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Full Flashing Procedure ===== | ||
+ | |||
+ | *Install WinPcap (only necessary for windows) | ||
+ | *Connect the ethernet cable from the AP51 router (ROBIN) to your computer | ||
+ | *May require a cross over cable or hub/switch with older equipment | ||
+ | *Power off AP51 router (unplug) | ||
+ | *Start FonFlash | ||
+ | *Select Firmware Type | ||
+ | *Gargoyle/ | ||
+ | *Fonera Firmware | ||
+ | *DD-WRT | ||
+ | *Select the ethernet device you are using | ||
+ | *Select the Gargoyle/ | ||
+ | *Select the Gargoyle/ | ||
+ | *Hit the Start button | ||
+ | *Wait 5 seconds | ||
+ | *Power on the AP51 router | ||
+ | *Wait 10 minutes - 30 minutes, until FonFlash reports that the router has been flashed | ||
+ | *Wait another 2-3 minutes while the router reboots | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||