Gargoyle Forum

Hi
I set up Gargolye on TP-Link 841N and TP-Link 1043. Problem is that after some days they lose it's settings and I have to set up again. It looks like router is reset to clear settings.
This is unusable for now. Could anybody help with this issue ?
With Regards

Under which version is this happening?

фор 841Н ис gargoyle_1.9.0-ar71xx-generic-tl-wr841n-v8 is for 841n,
for TP-Link 1043 ис gargoyle_1.9.0-ar71xx-generic-tl-wr1043nd-v1

With Regards

Try flashing the firmware again. It sounds like something is not right.

The 841 may be better off on 1.8.1

HI
Thanks a lot for your support. I will try with 1.8.1. I tried with two types routers to be sure that problem do not depend of hardware, but it reproduced with both of them. I will test with stable version and will return feedback with results.

With Regards