Page 1 of 1
Netgear WNR1000v2 support?
Posted: Wed Oct 14, 2015 8:31 pm
by jenom
Netgear's WNR1000v2 now is fully supported in OpenWrt Chaos_Calmer 15.05
Will it be supported in Gargoyle 1.9.0 when it becomes available ?
Thanks!
Re: Netgear WNR1000v2 support?
Posted: Thu Oct 15, 2015 1:51 am
by ispyisail
only 4 meg of flash
That is a problem going forward
Re: Netgear WNR1000v2 support?
Posted: Sun Oct 25, 2015 9:09 pm
by jenom
I can see a Gargoyle firmware on the download section for a similar AR7xx WNR2000, also with 4 MB memory.
Web-Gui LUCI loads pages a bit slow to my taste in Calmer-Chaos, however it seems very responsive in Barrier-Breaker.
My experience with Gargoyle GUI is that it was always worked faster then Open-Wrt's LUCI.
So it would nice to have a Gragoyle for WNR1000 either with BB or CC
Re: Netgear WNR1000v2 support?
Posted: Tue Nov 10, 2015 9:08 am
by t333to
WNR1000v2 has exactly the same hardware as WNR612v2, the only difference is the number of LAN ports. So if WNR1000v2 is supported the WNR612v2 should be to.
https://wikidevi.com/wiki/Netgear_WNR612v2
There is also a rebranded WNR612v2, the "On Networks N150":
https://wiki.openwrt.org/toh/netgear/wnr612v2
Re: Netgear WNR1000v2 support?
Posted: Mon Dec 28, 2015 11:23 pm
by jenom
Managed to put with tftp Open Wrt Barrier Breaker 14.07 with LuCI 0.12
Running without any issues!