Hi,
My WRT54GL is currently running dd-wrt.
Is there a different procedure for flashing gargoyle from dd-wrt? Or can I just use these 'traditional' steps?
1. Restore Defaults, 30/30/30 Reset
2. Upload gargoyle bin
3. 30/30/30 Reset
Flashing From DD-WRT
Moderator: Moderators
Re: Flashing From DD-WRT
Hi that should work but i dont think that 1.6.2 will run verry good on your 54gl as it will run slow because of the low RAM
and Flash memory. By all meens giv it a go but you mite want to use a older ver of Gargoyle. I dont no wich one tho.
PS I have never dun a 30-30-30 with Gargoyle it's just a ddwrt thing i think.
and Flash memory. By all meens giv it a go but you mite want to use a older ver of Gargoyle. I dont no wich one tho.
PS I have never dun a 30-30-30 with Gargoyle it's just a ddwrt thing i think.
Linksys WRT3200ACM
NETGEAR Nighthawk R7800
NETGEAR R6260
NETGEAR Nighthawk R7800
NETGEAR R6260
Re: Flashing From DD-WRT
Not to burst your bubble but newest gargoyle will be sluggish on your router ...jbsix wrote:Hi,
My WRT54GL is currently running dd-wrt.
Is there a different procedure for flashing gargoyle from dd-wrt? Or can I just use these 'traditional' steps?
1. Restore Defaults, 30/30/30 Reset
2. Upload gargoyle bin
3. 30/30/30 Reset
Re: Flashing From DD-WRT
Didn't get very far to see for myself I'm afraid.
Flashed the .bin as I did not see the .trx file so router is bricked.
Power LED flashing. Able to ping it eventually with reply but tftp connection is refused.
Any suggestions that don't involve jtag?
Flashed the .bin as I did not see the .trx file so router is bricked.
Power LED flashing. Able to ping it eventually with reply but tftp connection is refused.
Any suggestions that don't involve jtag?
Re: Flashing From DD-WRT
Correction it is NOT bricked. It just takes 15+ minutes to boot.
When you said sluggish I had no idea it would be this bad. I might as well be connecting to it from a 14.4k modem.
Any suggestions for a reasonably fast build?
When you said sluggish I had no idea it would be this bad. I might as well be connecting to it from a 14.4k modem.
Any suggestions for a reasonably fast build?
Re: Flashing From DD-WRT
IMHO u should use tomato firmware on the router .....
Just saying .
Just saying .
Re: Flashing From DD-WRT
Need the quota feature. And anyway i cant find a way to flash anything right now with the router so unresponsive. No tftp, no telnet, webgui fw uploads are perpetually uploading. Im running out of ideas...
Re: Flashing From DD-WRT
finally managed to change the rom by flashing a ddwrt micro build with putty,
Even 1.4.7 becomes sluggish when wireless is switched on. Guess I was expecting too much from this puppy.
The website really needs to be updated to reflect this...
Even 1.4.7 becomes sluggish when wireless is switched on. Guess I was expecting too much from this puppy.
The website really needs to be updated to reflect this...