I am experiencing reboot loop on my TL-WR1043ND v1 router I recently setup too. I am using Gargoyle 1.6.2 on it.
I see a similar message like yours just before the router reboots.
Code: Select all
[ 142.070000] ipt_bandwidth: timezone shift of 780 minutes detected, adjusting
[ 142.080000] old minutes west=0, new minutes west=-780
I don't think my problem is related to daylight saving. I had reset the router yesterday because it was having reboot loop after working fine for 2 weeks, configured to reboot daily. However, it go haywire on the next day...
In any case, the router is configured to NZ time zone and daylight saving was kicked in recently. Though the router reset I had described earlier is done after daylight saving... so daylight saving is probably not the cause.
If this router is not connected internet or any devices by WIFI, it seems to be running fine without reboot. But it will reboot after I press the backup configuration button and the error above will appear just before rebooting. In other words, the router will reboot BEFORE the compressed backup file is downloaded to the computer.
Note: this reboot behaviour cannot be reproduced after a reset by pressing the backup configuration button.
Is your router still working fine after you had reset/deleted the usage data? or did the same problem emerge again?
I am looking for a solution or way to figure out what is wrong with this router...