QOS - Could not add classification rule.
Posted: Fri May 31, 2013 11:13 am
I'm using TP-Link TL-WR741N/ND v1 router with Gargoyle router version 1.5.9. I have been using this firmware for several months now, and I love it, especially amazing QOS settings.
Today I was setting some QOS for gaming. I set all the settings and then clicked save. A dialogue came up about saving, but it didn't dissapear even after 20 minutes, so I refresed site. After that my settings are gone and I can't set new settings (L7 protocol), because I get error:
You have to left click on image and then choose show image.
I used Google to see, if there is anyone with the same problem and found this thread:
http://www.gargoyle-router.com/phpbb/vi ... ?f=6&t=821
There is a file at the end of first page, but I don't know how to use it
. Can someone help me?
Best regards.
Today I was setting some QOS for gaming. I set all the settings and then clicked save. A dialogue came up about saving, but it didn't dissapear even after 20 minutes, so I refresed site. After that my settings are gone and I can't set new settings (L7 protocol), because I get error:
You have to left click on image and then choose show image.
I used Google to see, if there is anyone with the same problem and found this thread:
http://www.gargoyle-router.com/phpbb/vi ... ?f=6&t=821
There is a file at the end of first page, but I don't know how to use it
. Can someone help me?Best regards.