QOS - Could not add classification rule.

[kebirad]

I'm using TP-Link TL-WR741N/ND v1 router with Gargoyle router version 1.5.9. I have been using this firmware for several months now, and I love it, especially amazing QOS settings.

Today I was setting some QOS for gaming. I set all the settings and then clicked save. A dialogue came up about saving, but it didn't dissapear even after 20 minutes, so I refresed site. After that my settings are gone and I can't set new settings (L7 protocol), because I get error:


You have to left click on image and then choose show image.

I used Google to see, if there is anyone with the same problem and found this thread:

http://www.gargoyle-router.com/phpbb/vi ... ?f=6&t=821

There is a file at the end of first page, but I don't know how to use it . Can someone help me?

Best regards.

[pbix]

There is not enought information in your post to tell what might have happened. I recommend you re-load your router with v1.5.10 in anycase since many bugs are fixed in that release.

The old post you referenced does not apply in your case. That issue was only in v1.3.9 and fixed long ago.