Pls forgive me if this post has already been answered, however can someone tell me if there is a recommended gargoyle firmware that will allow me to hard-wire two 1043ND's in a 1000/100 ethernet mode?
With the latest stock firmware's on both, they resort to connecting at 10mbps - so am currently using a small 100mbps switch between them.
TY!
PS> goes understood that i also am seeking stable wifi too
Daisy chaining two 1043NDs
Moderator: Moderators
Daisy chaining two 1043NDs
x2 Archer C5,C7 - Stock | x1 TL-WA730RE v1 - Openwrt 14.07 | x2 TL-WR1043ND v1.7 - Gargoyle v1.6.X http://goo.gl/VMbxcH | x2 WRT54GL v1.1 Tomato v1.28.7821 MIPSR1-Toastman-ND, 14929_vpn | x1 WHR-HP-G54 - Gargoyle 1.4.7
Re: Daisy chaining two 1043NDs
most likely stock firmware will provide the most stable wifiPS> goes understood that i also am seeking stable wifi too