Page 1 of 1
WNDR3800 Client Bridge / WLAN problem
Posted: Sat May 05, 2012 2:51 am
by equi
good morning from germany guys
yesterday, i've installed gargoyld on my new device and settet up the client bridge mode via the 2,4ghz device. Now, my 5ghz is disabled? i want the 2,4ghz to bridge and the 5ghz to open a new spot. isn't that possible?
best regards,
equi
Re: WNDR3800 Client Bridge / WLAN problem
Posted: Sun May 06, 2012 1:04 am
by tals
In operation modem on the connection page, Wifi section use dual band, you then have the 5ghz settings.
Out of interest I have never used this as I don't understand the advantages over standard wifi - can all devices connect to 5ghz or only specific ones and is it better?
Re: WNDR3800 Client Bridge / WLAN problem
Posted: Tue May 08, 2012 10:22 pm
by SkyBoss
tals wrote:In operation modem on the connection page, Wifi section use dual band, you then have the 5ghz settings.
Out of interest I have never used this as I don't understand the advantages over standard wifi - can all devices connect to 5ghz or only specific ones and is it better?
My understanding is only specific ones can connect and see 5ghz band.
Re: WNDR3800 Client Bridge / WLAN problem
Posted: Wed May 09, 2012 12:38 am
by tals
I think you are correct, I need to try the 5ghz and then see if any of my devices then work.
Did you get it working?