TP-Link -1043ND - No access to internet - WAN port not work

[w37]

I have TP-Link -1043ND HW ver. 1.8...
Today I upgrade my router from stock firmware (v.3.13.4 110429) to Gargoyle v.1.4.6 and v.1.5.3. After configuring Gargoyle I connect to WAN port my ADSL modem in bridge mode. WAN port not receive signal from ISP, led not flash...
Why?
Help me, please...

[hnl_dk]

I have TP-Link -1043ND HW ver. 1.8...
Today I upgrade my router from stock firmware (v.3.13.4 110429) to Gargoyle v.1.4.6 and v.1.5.3. After configuring Gargoyle I connect to WAN port my ADSL modem in bridge mode. WAN port not receive signal from ISP, led not flash...
Why?
Help me, please...

How do you connect to your ISP?
DHCP, PPoE. static...

if you connect with DHCP, is it possible that the DHCP lease of your old routersetup is blocking your access.
TP-Link is using a wrong MAC address for the WAN port, so after upgrading to Gargoyle/OpenWRT will you get the correct MAC address (that is different from the one of TP-Link).

You can call your ISP at get them to release your DHCP lease.

[w37]

I connect to my ISP with PPPoE...

[hnl_dk]

I connect to my ISP with PPPoE...

Okay,
I do not have that much experience with PPPoE.
I guess that you have tried to connect the WAN port to something else or with another cable. Just to make sure that it is the WAN port that has a problem.

[w37]

It was my first updating of firmware.
I configured Gargoyle through the Web-interface.
As how it is possible to change in a configuration in a command line?

[w37]

I connect to my ISP with PPPoE...

Okay,
I do not have that much experience with PPPoE.
I guess that you have tried to connect the WAN port to something else or with another cable. Just to make sure that it is the WAN port that has a problem.

I have returned on a factory firmware - all works.
Why doesn't work under Gargoyle?
At whom the same problem? How it to solve?

[ispyisail]

http://www.gargoyle-router.com/wiki/dok ... ridge_mode

If you can't bridge your ADSL router you might need to do double NAT

Also can you show us screen shots of you working config of your original firmware

[pmerrill]

I have a similar problem. I got up this morning, no internet access. I'm connected directly to the modem to type this. For some reason, 1.4.7 won't connect to the internet after multiple power up/downs of the modem and the router, it just won't connect.

What the's best way to debug? Are we talking a re-flash here? Is there a known problem? It's been working fine for a week, no problems and then this!

[Dik0j]

I have the same problem, WAN port after flashing doesnt working...
But i have found the solvation for this problem!!!
http://www.gargoyle-router.com/phpbb/vi ... 070#p12070