wzr-hp-g300nh leds

[KingJL]

Gargoyle 1.3.14 (client mode) on wzr-hp-g300nh
The security led and the internet (WAN connected) led does not function. I am not sure that the security led should function in a routed client mode, but the internet/connected led should. Is there a patch to make these work?

[sco77]

What's not working about it? My internet and Wifi LED lights seem to be functioning just fine on my g300nh.

[KingJL]

What's not working about it? My internet and Wifi LED lights seem to be functioning just fine on my g300nh.

What mode are you using (AP or Client)? If you are using Client mode, your comment/statement is valid, and I can do more research. If not...
If you notice, I specified my operating mode at the top of my post. In Client mode, the trigger that these leds are mapped to does not occur. In client mode these leds need to be mapped to a differnt trigger or the trigger needs to be mapped to some other event.

[KingJL]

Further sleuthung/experimentation finally provided a temporay solution. In /etc/config/system, i changed the device for the router led from 'eth1' to 'br-wan'. When I rebooted, the router led now is lit when a connection with a host AP is established.

I belive that Gargoyle shold be changed so that when configured as a 'routed client', the /etc/config/system file is edited correctly.

I do not know if this change will still function when configured as an AP. If it will, then only then just changing Gargoyle to configure this led as noted above would be all that is needed.