I have a strange issue, when i had a power failure,
it seems the original Linkysys WRT32X OS has loaded.
Can i somehow load back my gargoyle installation?
Or what exactly happened?
If not needed i would prefer not make a new installation again
Don`t think a reset was made, as my original password worked normal.
According to
https://openwrt.org/toh/linksys/linksys_wrt32x
it has a dual firmware flash layout.
How to boot in gargoyle again?
WRT 32X after power failure revert to original
Moderator: Moderators
Re: WRT 32X after power failure revert to original
https://openwrt.org/toh/linksys/linksys_wrt32x
Determine current partition:
/usr/sbin/fw_printenv -n boot_part
Boot primary
/usr/sbin/fw_setenv boot_part 1 && reboot
Boot Alternate
/usr/sbin/fw_setenv boot_part 2 && reboot
Solution found, if anyboy might need this in future
Determine current partition:
/usr/sbin/fw_printenv -n boot_part
Boot primary
/usr/sbin/fw_setenv boot_part 1 && reboot
Boot Alternate
/usr/sbin/fw_setenv boot_part 2 && reboot
Solution found, if anyboy might need this in future