I'm using wndr3700 on gargoyle 1.11.
I putted these commands
/etc/init.d/bwmon_gargoyle stop
/etc/init.d/bwmon_gargoyle disable
in
rc.local
saved and rebooted and still dosn't work. Whats wrong?
disablew bw monitor
Moderator: Moderators
Re: disablew bw monitor
In practice, you should just run the second command directly from cmd and restart the router:
... and the commands you have before exit0? It should be as follows:
Code: Select all
/etc/init.d/bwmon_gargoyle disable && reboot -f
Code: Select all
# Put your custom commands here that should be executed once
# the system init finished. By default this file does nothing.
/etc/init.d/bwmon_gargoyle stop
/etc/init.d/bwmon_gargoyle disable
exit 0
Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Re: disablew bw monitor
Ok cool, I have to edit the exit 0 at the end. But shall i run the first command you mentioned in putty or a reboot is enough?
Re: disablew bw monitor
This command will make the service not start when the router starts and the && will reboot the router.SirSWE wrote:But shall i run the first command you mentioned in putty or a reboot is enough?
Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users