Page 1 of 1
v1.11 WoL not working from openVPN
Posted: Fri Sep 20, 2019 12:20 am
by marshal
Upgraded Netgear 3800 from Gargoyle 1.5.10 to 1.11, all good except Wake-on-Line from openVPN. Tested that WoL is working in LAN environment, just not work if I connect remotely via openVPN. Was good in v1.5.7 though. Tried to port forward UDP 9 to that static IP, still not waken. Does anyone have any clue? Thanks!
Re: v1.11 WoL not working from openVPN
Posted: Fri Sep 20, 2019 7:26 am
by Lantis
Are you using WOL from the Gargoyle GUI, or from another tool running on the device connected to the VPN tunnel?
Re: v1.11 WoL not working from openVPN
Posted: Sun Sep 22, 2019 3:05 am
by marshal
I was using WOL from Gargoyle GUI.
Re: v1.11 WoL not working from openVPN
Posted: Sun Sep 22, 2019 4:04 am
by Lantis
It's working fine in my tests just now without any special settings.
There's no difference between using WoL whether you're on LAN or over VPN connected to the router. They both behave the same.