v1.11 WoL not working from openVPN
Moderator: Moderators
v1.11 WoL not working from openVPN
Upgraded Netgear 3800 from Gargoyle 1.5.10 to 1.11, all good except Wake-on-Line from openVPN. Tested that WoL is working in LAN environment, just not work if I connect remotely via openVPN. Was good in v1.5.7 though. Tried to port forward UDP 9 to that static IP, still not waken. Does anyone have any clue? Thanks!
Last edited by marshal on Sun Sep 22, 2019 3:09 am, edited 1 time in total.
Netgear WNDR3800 Gargoyle 1.5.10 now 1.11.0
Re: v1.11 WoL not working from openVPN
Are you using WOL from the Gargoyle GUI, or from another tool running on the device connected to the VPN tunnel?
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.
Please be respectful when posting. I do this in my free time on a volunteer basis.
Re: v1.11 WoL not working from openVPN
I was using WOL from Gargoyle GUI.
Netgear WNDR3800 Gargoyle 1.5.10 now 1.11.0
Re: v1.11 WoL not working from openVPN
It's working fine in my tests just now without any special settings.
There's no difference between using WoL whether you're on LAN or over VPN connected to the router. They both behave the same.
There's no difference between using WoL whether you're on LAN or over VPN connected to the router. They both behave the same.
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.
Please be respectful when posting. I do this in my free time on a volunteer basis.