Gargoyle Forum

hi,

im just use Gargoyle firmware a few day ago and notice that i cannot lock connection to 4g. there only option for auto 4g/3g/2g. is there anyway i cannot lock it? because when i using it on auto, the speed is fluctuated, when the speed is fast but suddenly it become so slow and i need to restart the router just to restore the speed

using huawei e398 with tplink tl-wdr3600

You can attempt to lock the protocol using the mode option
https://wiki.openwrt.org/doc/uci/networ ... i_protocol

This is done by manually editing the config.

not quite sure how to do it.. is there any example that i can use for config?

also, which protocol do you recommended with this type of config? wwan, qmi or ncm?

If you look at your /etc/config/network file it should be straight forward to figure out which bit to change.

I don't know anything about the protocols but i think they are hardware dependent rather than a choice.

will try later, thanks for your suggestion

also, is there indicator on the control panel that i can use to track my connection mode if i use this method?

No, not at this stage and I'm not sure if it is possible easily