Page 4 of 6
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:55 am
by oliver44
Can you give me a link to a website where i could buy the cable serial port, that i can connect to the router?
Maybe you have done this and you know the cable that can help me...
Thanks for patience and information, i will try to solve this problem.
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 11:01 am
by oliver44
It seems like now i have access to the router with WinScp and Putty, this after i gave a reset to defaults from GUI on OpenWrt.
How can i find if partitions are okay, what you recommend now if i have access with Putty?
http://s.go.ro/i3uzrhsc
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 11:31 am
by Rog66
in the GUI go to System-> Advanced Reboot -> Reboot to Alternative Partition
When the router reboots check what firmware is there - if its openwrt go back to the advanced reboot screen and see if the active partition is different to the first time you were there - if not the firmware on the alternative partition is no good. If its another firmware then the firmware on that partition is probably ok if the router booted into it.
Check the openwrt wiki for how to reflash various firmware's from openwrt.
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 11:46 am
by oliver44
It looks like everything is okay, the second partition I have the original linksys firmware, everything runs smoothly and very quickly the switch from one partition to another!
http://s.go.ro/i3uzrhsc
Re: wrt1900ACS (AC v.2)
Posted: Tue Oct 09, 2018 1:19 am
by oliver44
@Lantis How can i see if the partitions are okay, or everything is working fine?
As you can see above, now i have access to Putty and WinScp.
Re: wrt1900ACS (AC v.2)
Posted: Tue Oct 09, 2018 2:27 am
by Lantis
You can’t do much except for booting into each one to see if it works.
You can also dump the MTDs for each partition and examine the contents. Both of these methods require a bit of knowledge and understanding what you’re doing.
If it’s working, I’d leave it alone
Re: wrt1900ACS (AC v.2)
Posted: Mon Oct 22, 2018 11:11 am
by oliver44
[link removed]
Re: wrt1900ACS (AC v.2)
Posted: Mon Oct 22, 2018 4:48 pm
by Lantis
We can’t assist you with that here sorry
Re: wrt1900ACS (AC v.2)
Posted: Mon Oct 22, 2018 11:44 pm
by oliver44
@Lantis, i understand i did not want to bring any offense to this forum, i just wanted to show that wrt1900acs v2 is moving very well on OpenWrt!
I hope that Gargoyle will soon have the same performance as OpenWrt and support IPV6, congratulations for everything you do here.
Re: wrt1900ACS (AC v.2)
Posted: Tue Oct 23, 2018 1:43 am
by ispyisail
I hope that Gargoyle will soon have the same performance as OpenWrt and support IPV6
I doubt its going to happen any time soon.........
Who knows the future