wrt1900ACS (ACS v.2)

oliver44 · Post by **oliver44** » Sun Oct 07, 2018 1:55 am

Can you give me a link to a website where i could buy the cable serial port, that i can connect to the router?
Maybe you have done this and you know the cable that can help me...

Thanks for patience and information, i will try to solve this problem.

oliver44 · Post by **oliver44** » Sun Oct 07, 2018 11:01 am

It seems like now i have access to the router with WinScp and Putty, this after i gave a reset to defaults from GUI on OpenWrt.
How can i find if partitions are okay, what you recommend now if i have access with Putty?

http://s.go.ro/i3uzrhsc

Rog66 · Post by **Rog66** » Sun Oct 07, 2018 11:31 am

in the GUI go to System-> Advanced Reboot -> Reboot to Alternative Partition

When the router reboots check what firmware is there - if its openwrt go back to the advanced reboot screen and see if the active partition is different to the first time you were there - if not the firmware on the alternative partition is no good. If its another firmware then the firmware on that partition is probably ok if the router booted into it.

Check the openwrt wiki for how to reflash various firmware's from openwrt.

oliver44 · Post by **oliver44** » Sun Oct 07, 2018 11:46 am

It looks like everything is okay, the second partition I have the original linksys firmware, everything runs smoothly and very quickly the switch from one partition to another!

http://s.go.ro/i3uzrhsc

oliver44 · Post by **oliver44** » Tue Oct 09, 2018 1:19 am

@Lantis How can i see if the partitions are okay, or everything is working fine?
As you can see above, now i have access to Putty and WinScp.

Post by **Lantis** » Tue Oct 09, 2018 2:27 am

You can’t do much except for booting into each one to see if it works.
You can also dump the MTDs for each partition and examine the contents. Both of these methods require a bit of knowledge and understanding what you’re doing.

If it’s working, I’d leave it alone

oliver44 · Post by **oliver44** » Mon Oct 22, 2018 11:11 am

[link removed]

Post by **Lantis** » Mon Oct 22, 2018 4:48 pm

We can’t assist you with that here sorry

oliver44 · Post by **oliver44** » Mon Oct 22, 2018 11:44 pm

@Lantis, i understand i did not want to bring any offense to this forum, i just wanted to show that wrt1900acs v2 is moving very well on OpenWrt!
I hope that Gargoyle will soon have the same performance as OpenWrt and support IPV6, congratulations for everything you do here.

Post by **ispyisail** » Tue Oct 23, 2018 1:43 am

I hope that Gargoyle will soon have the same performance as OpenWrt and support IPV6

I doubt its going to happen any time soon.........

Who knows the future

Gargoyle Forum

wrt1900ACS (ACS v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)

Re: wrt1900ACS (AC v.2)