Page 3 of 6
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 12:16 am
by oliver44
Now i'm running on the first Linksys firmware partition, but here i'm having problems when I want to load a new firmware version....
http://s.go.ro/9s98c62n
To be honest i'm not an expert, where should i start to investigate this problem?
https://wiki.openwrt.org/toh/linksys/wr ... b__drivers
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:01 am
by Lantis
The images are so low resolution i can't even tell what is going on.
If you aren't trying to load Gargoyle, you might wish to seek help in a more appropriate forum?
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:15 am
by oliver44
Try to download those pictures you will see in the correct resolution, i uploaded them to a secure site from my internet provider
https://storage.rcs-rds.ro/
I tried the Openwrt forum, but i did not get an answer
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:20 am
by Lantis
That site wants me to log in. I'm not logging in to an unknown site
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:23 am
by oliver44
You do not have to log in, just access the links in my previous messages.
If you use firefox and click on the image you can open or save the images, or down in the right corner you can download the image!
Thx
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:28 am
by Lantis
You're trying to upgrade from 1 version of the OEM firmware to another? I can't help you with this.
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:36 am
by oliver44
Lantis wrote:You're trying to upgrade from 1 version of the OEM firmware to another? I can't help you with this.
This problem i encountered immediately after i managed to get back to the OpenWrt firmware, i thought it better to try and rewrite the original software on the on both partitions and i also noticed these anomalies...
After which i rewrote the Openwrt firmware !
Now i run OpenWrt and can not access the router via Putty and WinScp!
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:39 am
by Lantis
You can fix the entire problem with a serial connector to reflash both partitions properly.
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:42 am
by oliver44
Lantis wrote:You can fix the entire problem with a serial connector to reflash both partitions properly.
I have to write both partitions with a certain firmware?
Can you give me a concrete example from the
https://wiki.openwrt.org/toh/linksys/wr ... b__drivers that i have to follow?
Re: wrt1900ACS (AC v.2)
Posted: Sun Oct 07, 2018 1:48 am
by Lantis