Gargoyle-ispy 2014-July-28.7z

[out of rules]

Bump OpenWrt to r41503

https://dev.openwrt.org/changeset/41952 pls

[djt_nz]

https://dev.openwrt.org/changeset/41952 pls

That patch will only effect OpenWRT trunk. These builds from ispyisail will still be using OpenWRT Attitude Adjustment because that's the OpenWRT branch Gargoyle is built with.

Will need to wait and see if it gets back ported to Attitude Adjustment branch.

[ispyisail]

That patch will only effect OpenWRT trunk. These builds from ispyisail will still be using OpenWRT Attitude Adjustment because that's the OpenWRT branch Gargoyle is built with.

True

This week some time Eric is about to do a final build against AA

Then onto BB

[dieselz]

i am sorry for asking this here but i thought i'd try dd-wrt before trying your new release and now that i want to go back i am stuck.. whenever i flash any gargoyle bin it just restarts and back to the same firmware,
no firmware can be flashed from gui and the recovery window is too narrow i cannot successfully flash with tftp. could this be nvram problem?
or is there a bin i can use to go back to gargoyle please???
my quota is being abused and the people in my network is out of control i need to get back that easy-to-configure quota limit.
thank you.

[scrmtrey]

First go to stock firmware. Than flash gargoyle.

[dieselz]

i tried but nothing works, after flash i still get dd-wrt @_@
its so weird i used to switch between the two no problems via gui

[pmerrill]

You know you probably have to take Stock can cut down the bin file? There is a thread from memory on dd-wrt that has all the "back to stock" files as an attachment.

[n0pin]

I once faced this problem too. Everytime I tried to upgrade new firmware when using DD-WRT, it came back after reboot. Even webrevert images DD-WRT provides didn't work.

I solved this problem by using SCP to copy firmware image (beware, sometimes you need to use stripped image, depends on router) to /tmp folder on router. Then I issued this command (image.bin is name of the firmware file I uploaded):

Code: Select all

mtd -r write /tmp/image.bin linux

After that I finally managed to get back to factory firmware.

This could probably also solved using TFTP.

[scrmtrey]

Is it possible to have ipv6 DHCP on local network ? With gargoyle AA or BB later ?

[scrmtrey]

That patch will only effect OpenWRT trunk. These builds from ispyisail will still be using OpenWRT Attitude Adjustment because that's the OpenWRT branch Gargoyle is built with.

True

This week some time Eric is about to do a final build against AA

Then onto BB

When will be the first BB gargoyle version online ? Cant wait.