Bridge Mode - How to do it right

[SpudMuffin]

OK, yes... I am viewing the upsteam router's DHCP client list and there is no IP listed, however, the gargoyle AP is working, but I can't access the gargoyle??

[SpudMuffin]

What do I need to do to access my gargyle now that I have it operating as you suggested?

[Lantis]

If your upstream is not showing it as a client then what static IP did you set for it?

[SpudMuffin]

I only changed those things that you mentioned. However, over to the right on the config panel was 192.168.1.1,255.255.255.0,192.168.1.1... tried that but no success either..

Since I did a full reset, is there a default?

[ispyisail]

screen shots would be very helpfull

[SpudMuffin]

Yes, but I can't access GUI so can't get SS....

[ispyisail]

failsafe reset and start again

[SpudMuffin]

How do I set static IP? or choose DHCP?

[Lantis]

When you set connect via to disabled you can enter an IP address for the router.

[SpudMuffin]

Does it have to be the same subnet? If so, that is where I made my mistake earlier....