Installed today firmware image for TL-WR1043ND (gargoyle_1.4.2-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin) and got a problem with login by default admin password ("password"). Already rebooted router 1000 times and nothing helped. How could i bypass password and type new one? Or re-install/install another image?
Update: Pushed for 30-60 seconds hard reset button and it didnt even reset! I feel so bad that i already installed this image
incorrect default password
Moderator: Moderators
Re: incorrect default password
have you tried with a blank password?Roset wrote:Installed today firmware image for TL-WR1043ND (gargoyle_1.4.2-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin) and got a problem with login by default admin password ("password"). Already rebooted router 1000 times and nothing helped. How could i bypass password and type new one? Or re-install/install another image?
Update: Pushed for 30-60 seconds hard reset button and it didnt even reset! I feel so bad that i already installed this image
Router: TL-WR1043ND - Gargoyle 1.5.4
AP: TL-WR1043ND - Gargoyle 1.5.4
AP: TL-WR1043ND - Gargoyle 1.5.4
Re: incorrect default password
Use Failsafe mode from wiki
Power up your router. When the 'SYS' light starts to blink, press and hold the 'QSS' button in the front-right until the blinking gets faster. Now open a telnet session to 192.168.1.1. No user name or password required.
Write command
mtd -r erase rootfs_data
Erasing user space (rootfs_data) is the same as returning to OpenWRT firmware defaults, meaning you lose all configurations then reset the password.
Power up your router. When the 'SYS' light starts to blink, press and hold the 'QSS' button in the front-right until the blinking gets faster. Now open a telnet session to 192.168.1.1. No user name or password required.
Write command
mtd -r erase rootfs_data
Erasing user space (rootfs_data) is the same as returning to OpenWRT firmware defaults, meaning you lose all configurations then reset the password.
Re: incorrect default password
behappy, you are amazing! Thank you. After your suggestion i read all Gargoyle documentation and step by step configure my router.
P.s. From the beginning that was my fault, and Gargoyle image now is working fine for me.
P.s. From the beginning that was my fault, and Gargoyle image now is working fine for me.
Re: incorrect default password
For people who come across this in future: you can reset the password from failsafe mode without erasing data using the passwd command.
You may have to "mount_root" first if the passwd command gives you a read-only file system error.
SOURCE:
http://superuser.com/questions/355387/r ... to-default
You may have to "mount_root" first if the passwd command gives you a read-only file system error.
SOURCE:
http://superuser.com/questions/355387/r ... to-default