Hello,
I have dificult issue. I have 1043nd with newest gargoyle.
I switched to luci and everything was ok.
Next I switched back to gargoyle and now I can't login to root with any password.
What can I do with it?
regards
Qba
Gargoyle can't login
Moderator: Moderators
-
DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: Gargoyle can't login
Can you TFTP recover the router?
Or you might need serial access to re-flash.
Both Gargoyle and OpenWRT have a failsafe mode you can activate.
Follow the instructions on the OpenWRT wiki to get into failsafe
and then re-flash the firmware and allow it to reset to defaults.
Once thats done, you can putty in (not SSH!) and change the
password with the "passwd" command via command line.
Or you might need serial access to re-flash.
Both Gargoyle and OpenWRT have a failsafe mode you can activate.
Follow the instructions on the OpenWRT wiki to get into failsafe
and then re-flash the firmware and allow it to reset to defaults.
Once thats done, you can putty in (not SSH!) and change the
password with the "passwd" command via command line.
Soylent Green Is People! 2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400