Gargoyle 1.15.x BETA - 2024-11-13 - Based on OpenWrt 23.05

[angus]

Fantastic.
Did you change any of the default settings? You must have set your SSID at a minimum I think?

I did set the same SSID to 2.4G and 5G. Besides, fast roaming is enabled. Nothing's more.

[angus]

https://openwrt.org/docs/guide-user/network/wifi/usteer

I also notice there is a band_steering_threshold does not take effect unless load_balancing_threshold is also set to a value greater than 0. in the usteer page.

[whataboutnow]

VLAN required by ISP

Happy to see this build being released

can i just check please - my isp requires that I add a vlan ID to my connection details, is that supported in this build?


Many thanks

[Lantis]

VLAN required by ISP

Happy to see this build being released

can i just check please - my isp requires that I add a vlan ID to my connection details, is that supported in this build?


Many thanks

What device do you have?
I finished writing basic WAN side VLAN support last night and need a Guinea pig

[whataboutnow]

hiya sorry for the delay,
I have a wrt3200acm

Happy to do a couple of hours guinea pig over the weekend.

[Lantis]

hiya sorry for the delay,
I have a wrt3200acm

Happy to do a couple of hours guinea pig over the weekend.

I'm compiling a new version for you now. I'll post it in a few hours

EDIT: Available here https://lantisproject.com/gargoyle_cust ... lds/mvebu/

[marcinkk]

Redmi AX6000 is not supported by Gargoyle 1.15, but it is supported by OpenWrt 23.05.

So I've made the following steps:
- I've cloned gargoyle from github
- I switched to base_on_openwrt_2305 branch
- I've addedd to targets/mediatek/profiles/filogic/config:

Code: Select all

CONFIG_TARGET_DEVICE_mediatek_filogic_DEVICE_xiaomi_redmi-router-ax6000-stock=y
CONFIG_TARGET_DEVICE_PACKAGES_mediatek_filogic_DEVICE_xiaomi_redmi-router-ax6000-stock="gargoyle-large"

- I've addedd to targets/mediatek/profiles/filogic/profile_images:

Code: Select all

xiaomi_redmi-router-ax6000-stock-

Then I've run compilation with:

Code: Select all

make mediatek FULL_BUILD=true

And as a result I have:
gargoyle_1.15.x-mediatek-filogic-xiaomi_redmi-router-ax6000-stock-squashfs-sysupgrade.bin

What is a chance that my AX6000 will run proprely after sysupgrade to this image? It currently has OpenWrt SNAPSHOT installed.

[Lantis]

High chance. Sysupgrade without preserving settings.
If it works I’d be happy to add the device (as you have)

[fifonik]

I would like to install some plugins that I also used on wrt1900acs v2 but I don't know what the command is for GL-MT6000, for wrt1900acs v2 I use

Can you compare performance of your MT6000 with wrt1900acs please? Thanks.

[angus]

Hi Lantis,
Is there a date to release 1.15 final? Thanks.