Installation linksys ea7300 V1 Issues

[denisr]

Good morning, I'm trying to install garygole on a linksys ea7300 v1, but it always returns factory firmware. I have the latest factory version.

Any solution??

[pythonic]

See the OpenWrt ToH page installation instructions regarding the A/B issue.

[denisr]

Thank you very much, installed successfully, in case of returning to stock, would it be the same instructions as openwrt?
((remove the DC power jack. Plug it back in and the Linksys logo lights up. Then it goes off. Count 4 times “Logo lights up” and unplug the DC power jack.

Repeat about 3 times and the bootloader changes the boot partition)).???

[denisr]

Unfortunately I had to go back to linksys stock, after 10 minutes the router runs out of internet, even factory reset and same inconvenience..