Extroot/wireless problem

[willian]

Oh, I see a problem. The first is to create an extroot and then a custom configuration.

That was it. First you need to create the extroot and then configure the connections.
I just went back to the initial settings and reversed the steps:

1. Connected the pendrive, unmount, formatted and marked to be used as extroot
   
   and then, configured the WAN (PPPoE), LAN and WLAN connections.

Thank you so much.

@Lantis Thank you for your attention too.

[Lantis]

I’ll still give this a once over. I think the intent was that setting up the extroot copied all config with it.
So doesn’t sound 100% right, but as long as you are sorted I won’t rush into it.

[willian]

I’ll still give this a once over. I think the intent was that setting up the extroot copied all config with it.
So doesn’t sound 100% right, but as long as you are sorted I won’t rush into it.

Yeah, I thought that by enabling the extroot all settings would be copied, regardless of when it was done.