Version 1.11.0 : Based on OpenWrt 18.06

[Lantis]

I can't find download for wr741 and wr740.

Those routers are 4MB, and are no longer supported by Gargoyle (and generally Openwrt as well).
Sorry about that.
You could try sticking with an older version, but my recommendation would be to invest in an upgrade

[ispyisail]

I can't find download for wr741 and wr740.

end of life in respect to gargoyle

[LMP]

I can't find download for wr741 and wr740.

Those routers are 4MB, and are no longer supported by Gargoyle (and generally Openwrt as well).
Sorry about that.
You could try sticking with an older version, but my recommendation would be to invest in an upgrade

Yes, but it does not appear any more in the old versions like 1.10. He appeared before.

[RomanHK]

EDIT: Moved to the RC section, I'm sorry.
viewtopic.php?f=14&t=11829&start=160#p52111

[CBx86]

Fresh Meat!
Many thanks all guys!
Will try it tomorrow!

[ViBE]

I can't find download for wr741 and wr740.

Those routers are 4MB, and are no longer supported by Gargoyle (and generally Openwrt as well).
Sorry about that.
You could try sticking with an older version, but my recommendation would be to invest in an upgrade

Yes, but it does not appear any more in the old versions like 1.10. He appeared before.

i don't see either on the list at the older release. i still planning an update on my WR741ND. so it's heartbreaking.

[Lantis]

@lesbinary
I haven't ignored your feedback. I just want to take the time to address it properly, and for that i need to check a few things.

[goatman64]

First off, thanks for all the work on gargoyle!

I had a working config of 1.10.0 I made a backup of my config and applied 1.11.0, rebooted. I could see my wireless network but could not lease an ip.

Will try the following procedure tonight

Procedure for 1.10.x and above
To recover:

Install Wireshark on your computer.
Configure your computer with static IP 192.168.1.2
Connect your computer to a LAN port on the router.
Start Wireshark and monitor the LAN connection.
Powerup your router, when wireshark shows the first packet from 192.168.1.1 immediately press and hold the reset button on the back of the router for three seconds.
Router power LED should be flashing quickly. (Failsafe mode)
SSH via putty to “192.168.1.1”
at the Gargoyle prompt type firstboot
wait until the command prompt returns
power cycle the router.

[ispyisail]

I had a working config of 1.10.0 I made a backup of my config and applied 1.11.0, rebooted

What does this mean?

You installed 1.11.0 then used a backup config from an old version then broke your router.

If this is the case, this is expected behaviour

[goatman64]

Apologies on the poor explanation.

I had a working 1.10.0 config.
Applied the 1.11.0 upgrade and rebooted
After reboot I could see my wireless networks but couldn't join

I did not apply a backup from my 1.10 version.

I will try the recovery procedure later today.

Thanks