Loosing QOS configs when saving while in "init"

[dsalch]

I have noticed this problem for the last couple versions but have not seen anything on it.

Scenerio:

1. Firewall QOS enabled
2. Make a change on the QOS page
3. Save settings
4. make another change on that or the other QOS page
5. save settings (must happen within a few seconds of #3)

result = all QOS rules erased

I am unsure of the exact timing for step 5, but it seems to be anytime during the "init" phase after saving settings the first time.

[Lantis]

If you are using multiple tabs, this is guaranteed to cause a problem.
If you aren't, all i can suggest is slowing your actions down a little.

[dsalch]

not multiple tabs. Just anytime a QOS setting page is saved while the system is in "init" state seems to loose settings for qos, especially the rule definitions.

it is totally avoidable, yes, but with no warnings it is disappointing when an entire set is lost due to being a bit to quick.