Bleeding Edge (mvebu + AR71xx) gargoyle-ispy 2018-June-29 22:45

[Lantis]

The images might have exceeded their capacity and not generated. This should be better by release but not guaranteed.
I won’t debug your problem at this stage as I don’t think UPNP is even properly included in the build you are using.

[mojolacerator]

PLEASE generate an x86 image !

I am running this ; https://downloads.openwrt.org/releases/ ... ts/x86/64/

Works fantastic, but I miss the Gargoyle interface and all the pre-installed goodies.

There is a growing number of people parking their consumer routers and going with an old pc. I am running on an i5-2400, with 4gb ram, the network is just flying !!!

Any chances of this?

[ispyisail]

see down the bottom

https://github.com/ericpaulbishop/gargoyle/pull/693

My personal feeling Eric will wait for OpenWRT stable .

We are at RC1

[mojolacerator]

awesome!

[SisterFister]

Yes and no. If you know what you are doing, then yes. If not, it would be wise to wait a bit longer for the Custom profile to be reworked for the new version which will make it easier.

I'll wait. The router I use is pretty under the radar (though veeeeery similar to an Archer C7) and I don't want to have one of those late night sessions where I want to figure out what has gone wrong more than sleep.

In the meantime I'll get the source and see what the building is like. I've only done the image generator (with some patches for 4mb) for OpenWRT/LEDE.