Hi,
I had an issue this morning with one of the host not connecting to the internet. After checking, I realized that the IP was not added to my DHCP static IP allocation. So I added it and after saving lost all my static IP's. Now it seems I cannot save any settings. If I try adding a static IP via DHCP, it adds it to the list saves without issues. However, when I leave and re-enter the page, there is no entries. I have also tried to create a new admin password, but it keeps the old one all the time.
Router : TL-MR3420 with Gargoyle v1.9.1
Regards,
Vaughn
Settings not being saved
Moderator: Moderators
Re: Settings not being saved
Hi mate i am sorry but your router has just 4 meg flash 1.9.1 only just fits in the 4 meg flash and has problems saving settings. You can flash back to 1.6.2 or try and get a new router. If you know how you could build your self and leave out some packages.
Linksys WRT3200ACM
NETGEAR Nighthawk R7800
NETGEAR R6260
NETGEAR Nighthawk R7800
NETGEAR R6260
Re: Settings not being saved
Hi Tapper,
Is there a way that I can move the boot-up onto USB as with the standard OPENWRT. This worked great, as I then could imnstall plug-ins without issue.
I could give the firmware build a try. Are there any tutorials or info on this?
Also, does v1.6.2 have quota management?
Thanks,
Vaughn
Is there a way that I can move the boot-up onto USB as with the standard OPENWRT. This worked great, as I then could imnstall plug-ins without issue.
I could give the firmware build a try. Are there any tutorials or info on this?
Also, does v1.6.2 have quota management?
Thanks,
Vaughn