General discussion about Gargoyle, OpenWrt or anything else even remotely related to the project
Moderator: Moderators
-
crazydoc
- Posts: 1
- Joined: Sat Aug 28, 2010 4:55 am
Post
by crazydoc »
Hello!
I am sure this questions was already asked. But the search rejects "wan port for lan" because the words are too common
.
I use my WRT54GL as an access point to my wired LAN. I´d like to use the WAN port of the router as it was a LAN port. How to do this?
thx
-
DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Post
by DoesItMatter »
http://wiki.openwrt.org/oldwiki/openwrt ... figuration
Check that page for info
What you are searching for is the phrase:
Assign WAN port to Switch
Wan to Lan will turn up WAY too many search results.
Soylent Green Is People!
2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400
-
bluscape
- Posts: 4
- Joined: Sun Sep 05, 2010 3:06 pm
Post
by bluscape »
In "Connection->Basic->Internet/WAN" set the "Connect Via" either as DHCP or Static IP depending on your requirements.
Mine is set to DHCP (Wired) since the device it is connected to will provide it with an IP.
