cannot connect to modem at all

[dippa]

Hi all,
I got my hands on a tp-link for $20 and loaded gargoyle, all was find and I could like in and access the modem. I could only connect via a cable. I then changed in the basic config from gateway to wireless\bridge and now I cannot access the model at all.
Any help would be great as I'm not all the flash with modems...
thanks
me

[Lantis]

What version did you load.

You can use failsafe reset to put it back to default.

Google "openwrt failsafe"

[dippa]

Hi, thanks you for the reply, I loaded this one:
gargoyle_1.9.0-ar71xx-generic-tl-wdr3600-v1-squashfs-sysupgrade
I'm not sure if that's was the failsafe version or not
reg,

[Lantis]

If this was a fresh install you should have installed the Factory version.

All versions include failsafe.

[dippa]

thanks,
I believe I've got it in failsafe mode now as the indicator light is flashing real fast. but still not able to connect, I'll read the rest of the page first....
thanks

[dippa]

I can get it in failsafe with the light going at a 100miles per hour. but fail access the modem via the network cable in any of the ports, I've set my pc's ip address to 192.168.1.2 and subnet 255.255.255.0 as per the doc, but no success.....
any ideas?

[Lantis]

Are you using telnet?
https://www.youtube.com/watch?v=_NqHpRHl8gQ

Here's an instructional video.

[dippa]

thanks heaps! back up and running