gargoyle-ispy 2015-June-18 23:01.torrent

[Lantis]

can confirm the same results.

[simono_pl]

Yes ! Disabling upnp-> restarting the firewall -> enabling UPNP worked ! Thanks !
And yes, I did a "preserve settings".

Time to test 2^32 !

And Yes, Peakhour is a great little monitoring tool !

For me this metod for UPNP don't work with my QNAP NAS. I get on QNAP:
------ NAT PMP Diagnostics ------
initnatpmp() returned 0 (SUCCESS)
using gateway : 192.168.1.1
sendpublicaddressrequest returned 2 (SUCCESS)
readnatpmpresponseorretry returned -7 (FAILED)

[ispyisail]

Yes ! Disabling upnp-> restarting the firewall -> enabling UPNP worked ! Thanks !
And yes, I did a "preserve settings".

Time to test 2^32 !

And Yes, Peakhour is a great little monitoring tool !

For me this metod for UPNP don't work with my QNAP NAS. I get on QNAP:
------ NAT PMP Diagnostics ------
initnatpmp() returned 0 (SUCCESS)
using gateway : 192.168.1.1
sendpublicaddressrequest returned 2 (SUCCESS)
readnatpmpresponseorretry returned -7 (FAILED)

Did you try a fail safe reset? (Just in case..............)

[Lantis]

Networx actually fails eventually anyway. it seems that the upnp system built into windows is only 32bit. once you go over 4GB it just stops reading it. Mac's (linux ) must be immune to this problem.

[phgerin]

The UPNP connectivity to the router is lost after a few hours.
I have to disable-enable UPNP, restart the firewall to get it back !

[RomanHK]

I've tested, and it does not look UPNP error, but the error will be somewhere in the kernel. I even tried the old package mini-snmpd_1.2b-8_ar71xx.ipk - the error is repeated. Interestingly, the TL-WR1043_V2- ok, V1 is not ok.

[scrmtrey]

V1 is always problematic from history but the wii range is exceptional good

[tapper]

Hi in this build WDS is broke over 5.GHZ

[apvm]

I have build 20150604 installed and backed up my settings. Can you use the backup to restore my settings once I upgraded to this build? TIA

ps this is for a 1043ND v1.7

[wallacefung]

I don't know why the "Wake on Lan" pages shows repeated unknown host with I.P. 10.xxx.xxx.xx in same MAC address. I roughly count the number of unknown host with same MAC address is over 20 records.

Besides, it shows the mac address of CISCO router in the last record. The CISCO router got first number of I.P. address in the same subnet of my router on WAN side. It seems the WOL page wrongly shows the network device on WAN side.