I didn't define the router good

[ChaoscripT]

Hi,
I have TP-Link WDr4300,
I had installed Gagoyle firmware,
It works good.
Now after I logged in in 192.168.1.1,
I wanted to make it repeater, so I did like in this picture,
http://www.gargoyle-router.com/wiki/lib ... bridge.jpg

But in "AP/Gateway IP" instead of 192.168.1.1, I put 192.168.0.1,
Now I can't login to the router, what can I do please?

Regards.

[jimasek]

You have to enter IP address and mask from 192.168.0.0/24 subnet (for example 192.168.0.101 and 255.255.255.0
Then you can login on the router by 192.168.0.1 IP address

[ChaoscripT]

Hi,
Thanks for reply,
I can't even access the TP-link 4300.

Regard.s

[jimasek]

You need to restore factory defaults and reconfigure the router

[ChaoscripT]

But how ?
I can't find the router on net.

Regards.

[jimasek]

Press and keep button Reset for 15 sec.

[ChaoscripT]

Made few times reset,
But now I can't even view this router.
I connect it to Modem, then connect to computer, it's not connect, and I can't login on 192.168.0.1

Regards.

[jimasek]

Default IP address in Gargoyle is 192.168.1.1

[ChaoscripT]

After factory reset, it's back to tp-link firmware no ?

Regards.

[jimasek]

After factory reset, it's back to tp-link firmware no ?

No, I told about default Gargoyle settings.