Help In Buffalo WHR-HP-G300N

[CCNAhmed]

hi guys , simply i install "gargoyle_1.6.2-ar71xx-generic-whr-hp-g300n-squashfs-factory.bin" to my Buffalo router WHR-HP-G300N by web GUI installation, the router start with gargoyle very fine , but didn't save my configuration , I JUST CLICK FACTORY DEFAULT and now i can't login to it by 192.168.1.1 ,i ping it while restarting replay with 2 ping only..
NOW i can login to it by TELNET i can do this by press AOSS button quickly after the RED DIAG flash is off you will see the Router Green flash very fast..
Did i do something wrong,i ask please can one help me Revert this router to original buffalo professional Firmware or to dd-wrt Firmware or Gargoyle Firmware , i prefer Gargoyle i think will be good in tx power..........or help me with Telnet IP command ,how can i change the router IP to 192.168.11.1 using TELNET and save so i can use TFTP with buffalo , i use " ifconfig eth0 192.168.11.1 netmask 255.255.255.0 up ". it change the IP but i don't no how to save and restart in Telnet. Thanks to all

[ispyisail]

http://wiki.openwrt.org/doc/howto/generic.failsafe

http://wiki.openwrt.org/doc/howto/gener ... lsafe.mode

[tapper]

Hi CCNAhmed if you can login through telnet then type firstboot then press enter that should reset the router for you.