Can't access Gargoyle after repeater/bridge mode

[shinto]

I was having internet problem and was playing around with the settings and switch on Gargoyle's wireless bridge/repeater mode and now I can't even access my router. I tried resetting and power cycling a few times to no avail. How do I switch it back?

Router: TP-Link n750

[pbix]

If you cannot remember the IP address you set for the bridge then you should use the recover mode to run 'firstboot" and restore the default settings. See the Wiki.

[d0u6]

I too just goofed up on this..

Router reports;

Connection-specific DNS Suffix . :
Link-local IPv6 Address . . . . . : fe80::a8b5:b56d:51e3:f5e3%2
Autoconfiguration IPv4 Address. . : 169.254.245.227
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :

Without having a default gateway I can't even go into failsafe.. or atleast its not letting me. Is there anything I can do to resolve this?

[StopSpazzing]

The topic you posted in is from 2009, and has already been answered. So I don't see why you posted.