Meraki mini bricked by 1.5.10?

[uggla]

Hi!

I have a Meraki mini which used to run Gargoyle 1.5.9. I tried updating the firmware in the Gargoyle gui to 1.5.10. Now it seems unreachable on 192.168.1.1 and zenmap doesn't detect it. Ethernet leds are on/flashing. It's bricked, right? Not much I could do without a serial cable, right?

Cheers
Uggla

[BashfulBladder]

You tried failsafe mode, right?

http://wiki.openwrt.org/doc/howto/generic.failsafe

Where you change your computer's IP to 192.168.1.2?

[uggla]

I've tried that but tcpdump gave me nothing.

[BashfulBladder]

I've flashed a router with wonky settings before and I've had to use failsafe mode numerous times.

I'm on Mac OS X. At no time did I ever see my router "advertize" that crap. Just try to telnet in & see if its responsive.

[uggla]

Unfortunately there's no buttons on this device. Can I trigger failsafe in another way, for example by short circuit any of the serial pins?

[BashfulBladder]

No button? That's a problem.

http://wiki.openwrt.org/doc/howto/generic.debrick

See the line under "Stupid things people do" - its: pin shorting.

The wiki says you can still enter failsafe mode under the "Triggering via keyboard key combination in a serial console" section.