compatibility wrt300n 1.1

[celica]

is gargoyle is compatible ?

[DoesItMatter]

It should be - there is firmware images available for download

<<== Click Download

Architecture: Choose Broadcom

There is a 1.5.8 build

gargoyle_1.5.8-wrt300n_v11-squashfs.bin

[celica]

mode repeater work? thank

[celica]

it doesnt work i brick my router now i need to use serial ...

[celica]

i repair my router with jtag , i test this firmware and it s not compatible ... brick all the time the router , ping do not respond , web interface tooo...there are a way for gargoyle firm work in wrt300n v 1.1?
thank you

[pbix]

Since your router has only 4MB of flash i think there is no hope that it can be supported by gargoyle.

[Eric]

pbix: 4MB of flash is fine (though a little cramped). Bare Min requirements for Gargoyle are 4MB of flash and 16MB of memory, though that's really not ideal (especially the memory).

However, according to the OpenWRT table of hardware (http://wiki.openwrt.org/toh/start), this router has 8MB of flash but is a work in progress (note that v1.1 appears separately from 1.0).

There are a lot of routers that have firmware images built that I don't own and can't test (the cost to buy all these models is prohibitive) -- I just upload the majority of the firmware built by OpenWRT, and test on the most common models.

[celica]

i can test if you want because i have one wrt54g v2 3 4 and wrt 300n v1.1
i see poeple do it working with openwrt , but with control via serie .
the last firm for wrt300n is :http://downloads.openwrt.org/attitude_a ... x/generic/
and other post talking about the ethernet driver :https://forum.openwrt.org/viewtopic.php ... 852#p95852