Can't reset or setup config

[rodrigo_tuim]

Hello!
I have a problem and I would like to help.
I have two routers: thomson dwg850-4b and TP-Link wr741nd.
Gargoyle installed no wr741nd to use it as a bridge.
After installing the wifi signal couldn't detectable, then I into setup with cable, by default ip 192.168.1.1.
Did the bridge settings as described in the image here of site home (http://www.gargoyle-router.com/wiki/lib ... bridge.jpg).
But I used the WDS mode, not client bridge.
I changed bridge ip to 192.168.0.50 (tp-link), because the router thomson has 192.168.0.1.
Now I can't into setup mode with any of this ips, same plug the cable directly to the router.
And the worst thing is that I can't reset it, same holding the reset for many minutes.
What can I do to reset it or fix this problem?
Thanks and sorry for my bad english!!!

[rodrigo_tuim]

News: by failsafe the packages are all received on ping, but could not open connection on port 23 message is show by telnet.

[rodrigo_tuim]

For future users with same problem, reset 30/30/30 don't ok by me.
When i try again the telnet by windows XP (Win7 don't conect before).
After conection stable by telnet, used "mtd -r erase rootfs_data" and the router reset, enable the web browser setup.
Know that's ok!