The Netgear WNR2200 just recently got preliminary DD-WRT support. I was wondering if there's a vanilla version of Gargoyle available that I can try to flash on this router? This router has a recovery mode much like the WNDR3700.
Specs:
AR7241
64 MB RAM
8 MB SPI Flash
AR9287 2T2R PCIe
4 FE LAN, 1 FE WAN through AR7241 internal switch.
1xUSB 2.0
Test Build? WNR2200
Moderator: Moderators
Re: Test Build? WNR2200
Gargoyle is based on OpenWRT and since I do not see support for the WNR2200 there it is not supported in Gargoyle. For questions about when or if it would be supported you should post over at openwrt.org.
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM
Re: Test Build? WNR2200
Research indicates the WNR2200 firmware is a Netgear's modified version of kamikaze 7.09. Again, this is similar to the WNDR3700's which appears to natively run a fork of build 7.09.
Am I wrong to think the WNR2200 could therefore be supported? I'll pursue researching the development path over at openwrt.org. Thanks for the response!
Am I wrong to think the WNR2200 could therefore be supported? I'll pursue researching the development path over at openwrt.org. Thanks for the response!
Re: Test Build? WNR2200
Kamijaze is an old version of OpenWRT.ehren8879 wrote:Research indicates the WNR2200 firmware is a Netgear's modified version of kamikaze 7.09. Again, this is similar to the WNDR3700's which appears to natively run a fork of build 7.09.
Am I wrong to think the WNR2200 could therefore be supported? I'll pursue researching the development path over at openwrt.org. Thanks for the response!
Gargoyle is based on backfire, which is the newest version of OpenWRT.
Router: TL-WR1043ND - Gargoyle 1.5.4
AP: TL-WR1043ND - Gargoyle 1.5.4
AP: TL-WR1043ND - Gargoyle 1.5.4