Hi guyz,
I've try to install gargoyle 1.6.1 (gargoyle_1.6.1-ar71xx-generic-wrt160nl-squashfs-factory.bin) on my linksys 160NL (serial number CUR06)
three times it fails . Power led flash and nothing happened. I can recoverer using tftp & core.bin official firmware.
For now i've successfully installed openwrt (attitude adjustment 12.09) but my goal is gargoyle qos…
any help?
thanks
[SOLVED] Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
Moderator: Moderators
[SOLVED] Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
Last edited by croc on Tue Aug 05, 2014 8:24 am, edited 1 time in total.
Re: Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
You should try upgrading from OpenWRT to Gargoyle using sysupgrade image. Do not try to preserve settings.
Re: Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
Hi i have the 160nl and i upgraded from ddwrt. If flashing from openwrt dont work then give flashing from ddwrt a shot.
Linksys WRT3200ACM
NETGEAR Nighthawk R7800
NETGEAR R6260
NETGEAR Nighthawk R7800
NETGEAR R6260
Re: Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
May i should try gargoyle 1.5.10 (based on released openwork AA) or install from packages like http://www.gargoyle-router.com/phpbb/vi ... f=8&t=5453 (eric post)
which 160nl serial number do you have ? CUR01 or CUR06 ?
which 160nl serial number do you have ? CUR01 or CUR06 ?
Last edited by croc on Tue Aug 05, 2014 1:57 am, edited 4 times in total.
Re: Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
i confirm it works.
linksys -> openwrt AA -> gargoyle sysupgrade
linksys -> openwrt AA -> gargoyle sysupgrade
Last edited by croc on Tue Aug 05, 2014 1:58 am, edited 3 times in total.
Re: [SOLVED] Linksys 160NL (CUR06) & gargoyle 1.6.1 -> fail
Hi everyone, I'm using OpenWRT at the time, but i have a e2100l. I need to know if the FW for wrt160nl work fine with this other router, or if i need other FW to migrate.
Thanks a lot.
Thanks a lot.