Hi,
After flashing ver 1.11.0 on WRT3200ACM, the 2.4 Ghz radio does not come up.
Anyone else facing the same issue? I have guest network enable on 2.4 Ghz too.
2.4 Ghz WRT3200ACM on ver 1.11.0
Moderator: Moderators
Re: 2.4 Ghz WRT3200ACM on ver 1.11.0
on flashing did you preserve settings or use a backup file?
Re: 2.4 Ghz WRT3200ACM on ver 1.11.0
No it was a clean install. Did all the settings again.
Re: 2.4 Ghz WRT3200ACM on ver 1.11.0
Might be a hardware thing?
https://community.linksys.com/t5/Wirele ... -p/1172629
From memory Lantis said something about this?
another link
https://forum.openwrt.org/t/linksys-wrt ... ed/27866/6
https://community.linksys.com/t5/Wirele ... -p/1172629
From memory Lantis said something about this?
another link
https://forum.openwrt.org/t/linksys-wrt ... ed/27866/6
Re: 2.4 Ghz WRT3200ACM on ver 1.11.0
Should not be. It works fine with stock rom and dd-wrt.
The first link in your post refers to a very old rom. It was an issue at that time but it was fixed.
The second link in your post refers to WRT32X.
The first link in your post refers to a very old rom. It was an issue at that time but it was fixed.
The second link in your post refers to WRT32X.
Re: 2.4 Ghz WRT3200ACM on ver 1.11.0
Try this command:ad19 wrote:No it was a clean install. Did all the settings again.
Code: Select all
rm -f /etc/config/wireless && reboot
Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0
http://gargoyle.romanhk.cz custom builds by gargoyle users