I just bought a WRT3200ACM and I tried to install 1.10 version from Gargoyle web site then I tried from your site, but no luck, the router did not load the Gargoyle after the flash (power button just blinking and I got an error that router cannot be find) so I cannot connect to the router; then I tried 1.9 same issue.
My router should be from 2016 ( strange, we are in 2018 but that is on the box) and the firmware version is 1.0.6 186168, how is that possible
. I would like to install Gargoyle What you suggest?
oh, I am a little confused: the installation instructions specify that is a .bin file but it is actually .img; I am doing something wrong? Also the upgrade is a .tar file, am I right and both needs to be installed.
Also what you mean by not preserving the previous setting when you do the flash, how you do that, I did not find any info about this can you explain it please?