Want to share your OpenWrt / Gargoyle knowledge? Implemented a new feature? Let us know here.
- Posts: 40
- Joined: Fri Jun 07, 2013 3:39 am
I once faced this problem too. Everytime I tried to upgrade new firmware when using DD-WRT, it came back after reboot. Even webrevert images DD-WRT provides didn't work.
I solved this problem by using SCP to copy firmware image (beware, sometimes you need to use stripped image, depends on router) to /tmp folder on router. Then I issued this command (image.bin is name of the firmware file I uploaded):
After that I finally managed to get back to factory firmware.
This could probably also solved using TFTP.
Thank you n0pin that helped me a lot <333
i am back to gargoyle now and the new build is working fine
TP-Link WDR4300 H/W Rev.1.6 Gargoyle-iSpy 1.9.x / Netgear WNDR4300 Gargoyle-iSpy 1.9.x
- Posts: 16
- Joined: Wed Jun 12, 2013 10:30 pm
Some updates for my router - since last reconfiguration with disabling ANI and other known tips and tricks there is no any serious crashes with WiFi.
- Posts: 250
- Joined: Thu Jan 17, 2013 11:43 pm
tapper wrote:I cant wate for Gargoyle on my WD N750 it's grate with openwrt but its not the same as Gargoyle for me imo
I don't know if it was you who wanted the WD N750 backport into AA I used, but I uploaded it here:https://github.com/BashfulBladder/gargoyle-plugins
Read the instructions at the beginning of the patch file - there are lots of caveats.
Note: I did the port & lost interest in it. Haven't tested failsafe mode or upgrading via web to a newer build. I kept missing patches which caused the kernel to crash, so I had to flash via tftp.
This is the patch I used to enable kernel dubugging symbols or whatever its called in Linux
Code: Select all
--- a/target/linux/generic/config-3.3 2013-11-04 19:48:31.000000000 -0400
+++ b/target/linux/generic/config-3.3 2013-11-05 03:32:08.000000000 -0400
@@ -1272,8 +1272,8 @@
# CONFIG_JME is not set
# CONFIG_JUMP_LABEL is not set
-# CONFIG_KALLSYMS is not set
-# CONFIG_KALLSYMS_ALL is not set
# CONFIG_KARMA_PARTITION is not set
# CONFIG_KERNEL_BZIP2 is not set
# CONFIG_KERNEL_GZIP is not set
TP-Link WDR3600 v1.1 running 1.5.10+ L10n-English (Built 20130922 - OpenWrt r38093)
TP-Link WDR4300 running 1.5.10+ i18n-English (Built 20131010 - OpenWrt r38286)
- Posts: 1069
- Joined: Sun Oct 13, 2013 5:49 pm
- Location: Stoke-on-trent UK
thanks but I don't no how to use that pach. I hope we will get a bump to bb branch soon anyway thanks for sharing.
Linksys WRT1900AC V2 Gargoyle 1.11
Linksys WRT3200ACM OpenWrt Snapshot