Problem with Client+AP

Report wireless and/or network connectivity problems in this forum.

Moderator: Moderators

Post Reply
Posts: 89
Joined: Thu Apr 22, 2010 3:24 pm

Problem with Client+AP

Post by throughwalls »

I have given a friend a lovely little TP Link MR3040 running Gargoyle. He runs it in Client + AP mode.

He can configure it fine from a wired connection, but when he goes to a new location (where the wireless client is not properly configured), then the AP network is not visible.

He is using an iPad when travelling and so cannot connect over ethernet to do the required configure.

Why is the AP dependent on having a active Client connection? Is there a way of seperating them, so that the AP is always visible even when there is no Client connection?

Post Reply