Gargoyle Forum

Is there a Gargoyle version that's better suited for my purpose and the WR1043ND V2.1? It might be interesting/worthwhile for you to try Gargoyle v1.6.2 as you do not appear to be requiring an features new in 1.7.x Is it possible to downgrade from 1.7.x 2015-05-20 to 1.6.2 while preserving settings...

I've got a new TL-WR1043ND v2.1 and installed this version. Reason for using Gargoyle: This router has to operate in client mode to link a remote network segment to the main network, all in the same subnet. OpenWRT doesn't seem to support this, for AR71xx, but Gargoyle does. Install and configuratio...

OK, I was hoping it may be possible to go directly from DD-WRT to Gargoyle, has anyone done that? I did it, but not on the 1043, but on a 703. Original firmware is chinese, and I wasn't willing to install that one ;) IIRC, I had to update from the telnet login (mtd and such), as it didn't work from...

This would likely add a lot of wear to the flash chip. It should be possible to do it on a USB stick or a network drive.


Regards
Ektus.

Hi all,

turned out it was not a Gargoyle problem, but a misconfigured route entry on the main router.


Regards
Ektus.

Hi all, I've got a strange problem here. Network topology: Internet---LTE Router 192.168.1.1===WD MyNet Router 192.168.0.180===WLAN access point 192.168.0.28---WR941ND with Gargoyle 1.5.10 192.168.0.14===more devices The Gargoyle router is in Wireless Bridge/Repeater mode. My PC is connected to the ...

Hi all, I've got a TP-Link TL-WR941N/ND v2 running 1.5.10 and set to reboot daily. Network configuration is wireless repeater, management IP is set to static. All information is there and static, but upon reset the WR941ND issues one DHCP request to my main router and gets an address, which is then ...

Quick fix would be to configure it to reboot everyday. I've got similar problems with my TP-Link TL-WR941N/ND v2. It's running in Wireless Bridge/Repeater mode, the bridge is used to stream the signal from an IP camera to the recording device. It doesn't show the data rate as that one is WAN only (...