Gargoyle Forum

I tried flashing gargoyle_1.6.2-brcm47xx-squashfs.trx from DD-WRT, on a WNDR3300, and ended up with a brick. (power led flashing) I had to do a TFTP to return back to DD-WRT. I have not found a way to have gargoyle running on this AP, neither I know if it will work with both wifis, so I am back usin...

I also have problems with Gargoyle Version:1.4.2 and TL-WR1043ND I had no problems with 1.3.x I ve upgraded to v1.4.2 about a week now, and I get wifi-problems randomly every few hours/minutes on my laptop & tablet, while at the sametime desktop is fine (over ethernet) The symptom is that Wifi i...

Thanks! it did work...

For the record:
I wanted to do some USB HDD transfer tests with the stock firmware.
I get 6-4MB/sec on LAN , and only 600-800kb/sec on WAN ...

link does not work anymore Are these the same as the one on the TP-LINK site ? Or will these brick the router ? http://www.tp-link.com/support/download.asp?a=1&m=TL-WR1043ND I found another source for stock firmware: http://samiux.blogspot.com/2010/03/howto-dd-wrt-on-tp-link-tl-wr1043nd.html Can...

I use gargoyle_1.3.7 on a TP link wr1043nd. I have installed transmission So far I have two problems: 1) USB mount is not always working automaticly... I use an SD card with a 2GB ext3 partition. Tried a USB flash of 4GB but it does not work (?) (will deal with this in the future) Have not tried wit...

I am also newbie, also trying to do the same. This is what I did, and it seems to be working... I have an ADSL modem at ip 192.168.1.1 with DHCP deamon I want openwrt to act as a "transparent" AP. I do the following: disable WAN/Internet set gargoyle router IP 192.168.1.100, gateway,dns 19...

ok failsafe worked, I had to press the front button (QSS) I was pressing the back one...

so I did a mtd -r erase rootfs_data
and device is visible again.

Thanks!

thanks for the prompt reply, I used the polish version (without realizing it before hand) because thats on the openWRT page of the device http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd sorry to bother you with failsafe, but, how does it work ? causeI have tried booting with the reset button pressed...

Hello there to all the gurus :-), Congrads on the great work! Unfortunately, I can not connect to wr1043 anymore, with no aparent reason. :-( I flashed Gargoyle 1.3.5 + Backfire 10.3.1-RC3 using this http://openwrt.groov.pl/WR1043NDv1/gargoyle-pl/ But userinterface was in russian or polish or someth...