Gargoyle Forum

If I turn off DHCP on my AP, and its just repeating the signal its getting from the LAN. Will it still be able to do Wireless Client Isolation?

I have a gateway device that will run all my DHCP.

Gateway Device --Wired--> MR3201a (with gargoyle)

I want the MR3201a to act as an wireless AP, so when people connect to it, they are actually getting the IP from the gateway device.

What should my setup on the MR3201A be??
thanks!

Ok I found client + ap mode. I had to choose gateway. then Connect Via: DHCP (Wireless) then at the bottom I get the Client + AP mode. I chose that. Then on the very left I chose DHCP and turned it off. Doesn't seem to be working still. I want another unit to be doing all the DHCP routing. The gargo...

I just upgraded to 1.3.5, and the Connection page looks exactly the same as 1.2.5. I also made sure it was 1.3.5 that I was looking at.

The settings I've mentioned above are those that I see for both, Gateway and Wireless Bridge / Repeater.

I'm using Gargoyle 1.25 for MR3201a. Ok, I hit wireless bridge at the top: then I get the options Router IP and AP/Gateway IP. Router IP should be this device correct? and AP/Gateway IP should be the device doing all the DHCP? then under Wireless i have 2 options: "Connect via WDS" "C...

Thanks for the help. Unfortunately I'm still not getting it. I don't see Client + AP anywhere. At the very top: Gateway or Wireless Bridge? If its gateway: Connect via: DHCP (wired) Ethernet port: WAN LAN Router IP: should this be this device, or the device doing all the dhcp routing? Wireless: AP, ...

I'm using a device called OMW from anaptyxmesh to do all my dhcp routing. I have an MR3201a with gargoyle on it. I want it to take the signal from the OMW and repeat the signal. Internet -> OMW ->wired-> MR3201a what settings should i be setting gargoyle up with? I've tried it as a gateway, under co...