Gargoyle Forum

Thanks for the new build :) I flashed it on my wrt1200 with preserve settings checked as i always do. Which worked always fine. I upgraded from the last feb build. Everything seems fine at first. But after editing some acc settings my device went dead? I did exactly the same on mine tp link wr1043n...

Thanks for the new build

I flashed it on my wrt1200 with preserve settings checked as i always do.
Which worked always fine.
I upgraded from the last feb build.

Everything seems fine at first. But after editing some acc settings my device went dead?

On openwrt 15.0.5 release build the wan led works fine. However on latest trunk the led is not working. The setup for the led in /etc/config/system is the same on both builds and on gargoyle. So i think it is an openwrt bug. My power led is only blinking during boot i think. After booting it is stea...

I just asked in the openwrt wrt1900 thread.
Maybe somebody has an idea there.

But i noticed on gargoyle firmware my wan led isnt working? on openwrt it works fine. Can you please have a look?
Thank you

I found this in the ddwrt forum: <Kong> wrote: E.g. working example for the 1900AC V1: swconfig dev switch0 set reset 1 swconfig dev switch0 set enable_vlan 1 swconfig dev switch0 vlan 1 set ports "5t 0 1 2 3" swconfig dev switch0 vlan 2 set ports "5t 4" swconfig dev switch0 set ...

Thanks again

Yes got it working again
Thanks for your help!

I flashed openwrt again to check vlan config there just for testing.
But there is nothing in the gui for vlans?
Maybe vlans aren't supported on the marvell platform?

And how to flash firmware to the secondary flash?

Okay this seems very strange.
It seems Router config got reseted. DHCP not working.
With Static IP Set on my client im able to access the web Interface. But i cant login because of wrong password?
Or is this the fail safe mode?

//edit
Okay the password is password xD

I cant tell if fail safe isn't working because i cant get the timing right.
How long did you wait after you power on ? 30 seconds?

I think the openwrt wiki is wrong about wrt1200 port layout?
WRT1900
LAN
0 1 2 3 5
WAN
4 6

WRT1200
LAN
0 1 2 3 6
WAN
4 5

Maybe that was the problem.

The wiki states as soon as any other led blinks turn off and on again.
The problem is only power led works.
i tried different timings but no go.
On your device when the power led starts blinking how long does it take to other leds light up?